E6000 2 Fl oz Multi purpose Craft Glue

A: E6000 does great with most surfaces but may have low adhesion to some plastics. To help increase the bonds strength, first scuff-sand and roughen the surface with sand paper. Wipe the area clean with acetone or rubbing alcohol and treat the product as a contact adhesive, meaning apply the product to both surfaces and allow 2-3 minutes for the product to get tacky before mating the two together and clamping/securing with weight for 24 hours. Thank you for your support of Eclectic Products & Target!

A: There is no need to use a new application tip each time E6000 is used. Try reusing them by cleaning with alcohol or acetone after each use. Thank you for your support of Eclectic Products & Target!

A: E6000 bonds very well to nylon and other fabrics, but sometimes "crinkle backpacks" have a water and stain proof sealant applied that may prevent quality adhesion of the E6000. For best results, wipe clean the bonding area with rubbing alcohol prior to applying. Treat the product as a contact adhesive, meaning, apply the product to both surfaces and allow 2-3 minutes for the product to get tacky before mating the two together and clamping/securing with weight (or tape) for 24 hours. Thank you for your support of Eclectic Products and Target!

A: E6000 is a solvent based product that may negatively affect the memory foam. It will bond and hold very well to fabric, but it may be best to try a small area on the foam to ensure it does not affect the mattress. Thank you for your support of Eclectic Products & Target!

A: Hi Spunk! E6000 will bond well to polyester! For best results, be sure the surface is clean, dry and free of oils. Apply the product to both surfaces and allow 2-3 minutes for the product to get tacky before mating the two together and clamping/securing with weight for 24 hours. Thank you for your support of Eclectic Products & Target!

A: Hi Sunshine! E6000 should work on your application! We recommend lightly scuff sanding both surfaces and wiping well with alcohol. Then, apply in a thin layer and allow product to cure for at least 24 hours. 72 hours will be a full cure. Thank you for your support of Eclectic Products & Target!

A: Hi BusyLizzieBe! E6000 should work well for your application. For best results, apply the E6000 to both surfaces and spread smooth. Allow 2-3 minutes for the product to get 'tacky' before mating the two items together and clamping/securing/pressing for 24 hours. Thank you for your support of Eclectic Products & Target!

A: Hi Leslie! E6000 works great for securing crystals to glass. For best results, clean both surfaces with rubbing alcohol prior to application to remove any oils/barriers that may impact adhesion quality. We strongly recommend that if you plan to drink directly from the glass bottle, ensure the mouth will not come into contact where any adhesive is applied. Always use a straw or lid when drinking if the adhesive has been used on or near the rim of the bottle. Thank you for your support of Eclectic Products & Target!

A: E6000 adheres very well to wood and should hold fine, but ensure there is enough surface area for the adhesive to hold onto. Treat the adhesive as a contact adhesive, meaning, apply to both surfaces and allow the product to be exposed to the air for 2-3 minutes before mating together and clamping/securing for 24 hours. Thank you for your support of Eclectic Products & Target!

A: Hi Amy! Yes, E6000 works great on denim! It is widely used to attach patches and even mend fraying hems. E6000 is washer/dryer safe once fully cured and will remain flexible and move with the cloth. Thank you for your support of Eclectic Products & Target!