A:Â As a follow up....adjust the sensitivity of the reaction using the Volume down and Volume up buttons on the remote. Note, sound reaction depend on the volume and distance of the music from mic.
A:Â No app required. The strip lights have a sound reactive microphone built into the USB connector to listen for and react to the sounds in the room. Use the remote to select one of the 4 sound modes.
A:Â Hello Lana, Thank you for your question. It all depends on the paint, the surface and the care taken when removing the strip. The light strip will will likely be easier to remove from a glossier paint surface rather than a flat paint. I hope this is helpful. If you have further inquiries, please contact us at support@westandarrow.com. Thank you.
A:Â What I do is use clear "hooks" on the wall and then make the LED lights nice and tight. If I want to change them. I just need to take them down from the hooks.
A:Â The strip light has a sound reactive microphone built into the USB connector. Select one of the sound reactive modes on the remote control and the lights will react. Use V-/V+ to adjust sensitivity.
A:Â Hi Blaze..no, this is USB powered. The remote control requires a battery, but it is included.
A:Â Hi Rose1234..please reach out to support@westandarrow.com for further assistance.
A:Â Hi Kristi Y...no, you cannot connect two sets of strips together.
A:Â Hello....this strip light is 8.2 feet long
A:Â Hi Devij...sorry to hear this. Please reach out to support@westandarrow.com for further assistance.
A:Â Hi Ruben...Please check whether the positive and negative poles of the light strip and controller are connected correctly. Otherwise, please reach out to customer support at support@westandarrow.com.
A:Â Hi Hannah...confirming these are 8mm LEDs.