Brixwell Replacement Washer Or Stud Kit For Single-Sided Pull Handle 1/4"-20 Threaded Rod, 1-1/4" Diameter End Caps, Brass And Plastic, Brushed Nickel

The Brixwell Replacement washer or stud kit is designed for use with single-sided solid pull handles to support proper mounting and spacing during installation or replacement. It is intended for solid pull handles with a diameter of 3/4". The kit includes two 1/4"-20 threaded rods, each supplied with a matching end cap. The end caps measure 1-1/4" (32mm) in diameter. Two metal washers with a diameter of 1-1/4" are included, along with six plastic washers consisting of four large washers and two small washers. The components are manufactured from brass and plastic and finished in Brushed Nickel to provide a uniform appearance when installed. This kit is used to replace worn or missing mounting hardware on compatible pull handles and does not change the original handle dimensions. All parts are sized as manufactured and should be verified before installation. Installation steps are 1) Remove the existing handle and hardware from the door, 2) Insert the 1/4"-20 threaded rods through the handle mounting holes, 3) Position the plastic washers as required between the handle and door surface, 4) Place the metal washers and end caps on the opposite side, 5) Align the handle to the correct position, and 6) Tighten the threaded rods evenly until the handle is secure without overtightening.