Reference 7005A 5-channel amplifier provides a full system solution without breaking a sweat and it'll look good doing it. It delivers 50-Watts RMS to each of the front and rear speakers and a ground-pounding 500-Watts RMS to the subwoofer channel a much better balance of "speaker-to-sub" power than most of the conventional 5-channel amplifiers on the market. For higher output you can bridge the amp to 3-channel mode and power your front speakers with 140-Watts per channel while still delivering 500-Watts to the subwoofer channel. Speaker-level inputs allow the Reference 7005A to work in almost any system even if you're keeping your factory radio. Separate high-pass and low-pass crossovers on the front and rear channels and dedicated low-pass crossover bass boost and phase switch for the subwoofer channel provides an incredible amount of control and tuning capability. The Reference 7005A is truly a total system solution in one easy to install chassis.

Compact sizeThe Infinity Reference 7005A amplifier features a low-profile chassis and a small overall footprint to fit in more vehicles where available space is limited.

High and low-level inputSpeaker-level and low-level inputs allow the Reference 7005A to integrate with both aftermarket and factory car stereo systems.

Variable crossover and bass boostUnlike many amplifiers available at similar prices Infinity Reference amps feature variable electronic crossovers and bass boost circuits to allow for fine-tuning.

Low noise and distortionProduces tight bass with low distortion at high SPL. Balanced Differential Inputs are used to ensure low noise.

Input Level ControlWhen low-level inputs are used this control adjusts the input sensitivity between 200mVrms and 2.0 Vrms. When high-level inputs are used this control adjusts the input sensitivity between 2Vrms and 20Vrms.

Full on-board protectionThe on-board circuitry to protect them from shorts temperature overvoltage and under-voltage. An LED indicator is included in all four models to let you know when one of these conditions exists.

Phase SwitchThis switch changes the input phase to inverted or non-inverted. This is especially helpful with the subwoofer channel.

RBC wired remoteThe RBC wired remote is an easy installation and can be mounted for convenient volume adjustment from the driver's seat.

What's in the Box
•One Reference 7005A five-channel amplifier
•(4) Bare wire-to-RCA adapters
•Six 30A ATO fuses (3 installed 3 spare)
•Remote bass control module
•16.5' Remote control cable (RJ-25 plugs on both ends)
•(2) Self-tapping screws for remote (M3 x 15mm)
•(4) Mounting screws (M4 x 53mm)

Specifications
•Power Output
•50 watts RMS + 320 watts RMS @ 4 ohms
•65 watts RMS + 500 watts RMS @ 2 ohms
•140 watts RMS @ 4 ohms + 500 watts RMS @ 2 ohms


•Variable high- and low-pass filters: 32-320 Hz 12 dB/octave on front and rear channels
•Low-pass filter: 32-320 Hz 12 dB/octave on subwoofer channel
•Bass boost: 0-12dB at 45Hz
•Phase switch: 0 180 degrees
•Preamp and speaker-level inputs
•Fuse rating: 30A x 3
•4-gauge power and ground leads recommended wiring and hardware not included with amplifier
•Dimensions (W x H x D)
•14-3/16 x 2-3/16" x7-1/8