Infinity MARINEM7005A 5 channel marine amplifier

5-channel amplifier provides a full system solutions without breaking a sweat, and it'll look good doing it. It delivers 50-Watts RMS to each of the front and rear speakers, and a ground pounding 500-Watts RMS to the subwoofer channel — a much better balance of "speaker-to-sub" power than most of conventional 5-channel amplifiers on the market. For higher output, you can bridge the amp to 3-channel mode and power your front speakers with 140-Watts per channel, while still delivering 500-Watts to the subwoofer channel. Speaker-level inputs allow the marine 7005A to work in almost any system, even if you're keeping your marine's factory radio. Separate high-pass and low-pass crossovers on the front and rear channels and dedicated low-pass crossover, bass boost, and phase switch for the subwoofer channel provides an incredible amount of control and tuning capability. The marine 7005A is truly a total system solution in one easy to install chassis. Specifications: 50 watts RMS x 4 + 320 watts RMS x 1 at 4 ohms 75 watts RMS x 4 + 500 watts RMS x 1 at 2 ohms 100 watts RMS x 2 bridged at 4 ohms + 500 watts RMS x 1 at 2 ohms Variable high- and low-pass filters (32-320 Hz, 12 dB/octave) on front and rear channels Low-pass filter (32-320 Hz, 12 dB/octave) on subwoofer channel Bass boost on subwoofer channel (0-12dB at 45Hz) Phase switch on subwoofer channel (0, 180 degrees) Preamp and speaker-level inputs Fuse rating: 30A x 3 4-gauge power and ground leads recommended — wiring and hardware not included with amplifier WxHxD = 360mm x 56mm x 180mm/14-3/16” x 2-3/16" x 7-1/8” What’s in the box One marine 7005A five channel amplifier 4 Bare wire-to-RCA adapters Six 30A ATO fuses (3 installed, 3 spare) Remote bass control module 16.5' Remote control cable (RJ-25 plugs on both ends) 2 Self-tapping screws for remote (M3 x 15mm) 4 Mounting screws (M4 x 53mm) Owner's Manual 2 Infinity decals 1 logo badage