A: E6000 will bond metal to rubber very well but it is not a food grade or food safe adhesive. Additionally, the upper tolerable temperature for E6000 is 180F; we do not recommend its use for this application. Thank you for your support of Eclectic Products and Target!

A: E6000 is a great choice for repairing shoes. It is a very strong adhesive that will flex with the shoe during use. It is fully waterproof and can withstand temperatures up to 150 F once fully cured. Thank you for your support of Eclectic Products and Target!

A: E6000 is a very strong and flexible adhesive that will not dry hard and brittle. It will be able to move and flex upon a full cure. Thank you for your support of Eclectic Products and Target!

A: E6000 Craft is a great choice for mending automobile seat vinyl. It will hold well and flex with the vinyl during use. Its temperature range once cured is -40--180 F, so it should perform well. Thank you for your support of Eclectic Products and Target!

A: No, E6000 is a solvent based adhesive that cures via the solvent evaporating. This takes about 24 hours for a cure, but it can take up to 48 hours for a full cure. Thank you for your support of Eclectic Products and Target!

A: E6000 is a great choice for repairing ceramic and resin items. E6000 is clear, waterproof, and has over 2,000 lbs./square inch of strength. For best results, first clean the surfaces with acetone or rubbing alcohol. Thank you for your support of Eclectic Products and Target!

A: E6000 will work great for this application! Apply the adhesive to both surfaces to be bonded and allow it to partially cure for approximately 2 minutes before mating the surfaces together. Allow repair to cure for 24 hours. Depending on the materials and temperature, maximum strength may not be reached for 48 to 72 hours. Thank you for your support of Eclectic Products and Target!

A: E6000 is a great choice for bonding nylon-to-nylon. It will hold the patch very well. For best results treat the product as a contact adhesive, meaning apply the product to both surfaces and allow 2-3 minutes for the product to get tacky before mating the two together and clamping/securing with weight for 24 hours. Thank you for your support of Eclectic Products and Target!

A: E6000 bonds great to repair ceramic and other mug materials and should do a fine job repairing the handle. However, its upper temperature limit is 180 F, so very hot beverages may cause the adhesive to soften and loosen. Thank you for your support of Eclectic Products and Target!

A: E6000 is offered in a few different sizes and packaging configurations. Any tube that has a tapered tip (like the 2.0 oz. craft product) is our Low Viscosity formula, which is thinner than our Medium Viscosity which comes in larger tubes (3.0 oz. and 3.7 oz.). E6000 "Multi-Purpose" is verbiage Target uses for our adhesive. The only difference between these items is their thickness--strength, set time, cure time, elongation/flexibility, etc. are all the same. Thank you for your support of Eclectic Products and Target!