Planet Audio Anarchy AC2000.2 2000W High Output 2 Channel Black Car Amplifier

The Planet Audio Anarchy AC2000.2 2000W High Output 2 Channel Full Range Class A and B Amplifier in Black comes with full-range Class A and B and MOSFET power supply. It has high- and low-level inputs, Variable High Pass Crossover, Variable Low Pass Crossover, and Variable Bass Boost. Remote subwoofer control is also included.2 Ohm StableThe lowest impedance accepted by this amplifier is 2 ohms. Amplifiers that are 2 ohms stable produce more power resulting in more volume. This amp can comfortably power speakers or subwoofers with all channel(s) being used at a load of 2 ohms.Class A and BClass A and B amplifiers have long been known for their ability to produce great quality sound while performing more efficiently than pure Class A amplifiers. Planet Audio has developed a specific linear circuitry that further reduces distortion while increasing both sound quality and power output.High- and Low-Level InputsAn amplifier with both high-level and low-level inputs provides flexibility by allowing you to build an audio system using virtually any standard factory or aftermarket source unit. High-level (speaker level) inputs accept the signal from the speakers, while low-level (RCA) inputs accept the signal from the pre-amp outputs of the source unit.MOSFETMOSFET stands for Metal Oxide Semiconductor Field-Effect Transistor. MOSFETs are used either as a switch or to amplify a signal. MOSFETs are superior to other FETs, because they require less current to operate, which makes them better suited for car audio.ProtectionIf the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself.Subwoofer Level Control and Switchable Input SensitivitySubwoofer Level Control is the ability to boost or attenuate the sub level when an amp and subwoofer are connected to the subwoofer pre-amp output. Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed.Variable Controls and FiltersVariable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it. Variable Gain Control lets you balance the amps output with the speakers or subs the amp is driving. Too much gain will lead to distortion and to little will lead to clipping. Variable high-pass filter gives you control over the frequencies that pass through to the full range speakers. Variable low-pass filter gives you control over the frequencies that pass through to the subwoofer.