desk hardware pulls

Center-to-center sizes listed for this selection range roughly from 3.75 inches up to 6.31 inches, with intermediate sizes such as 5.06 inches also shown.

Most listed pulls are sold in 10-piece value packs and note that installation hardware is included. One brass option lists a package quantity of four and also specifies included screws.

Measure the distance between the existing mounting hole centers on your drawer or door and match that center-to-center measurement to the pull’s listed center-to-center size. The product notes explicitly recommend using that measurement to choose the correct size.

Listings indicate most pulls include mounting hardware for straightforward installation using screws from the back of the drawer or door. Some finger/edge-style pulls are designed to mount from the back or over the front and can be positioned to cover pre-drilled holes.

Reported overall lengths range approximately from 4.58 inches up to 8.62 inches. At least one edge-style brass pull lists a projection (protrusion) of about 1-3/4 inches (44 mm) from the drawer face.

Width and thickness values vary by style but commonly fall around 0.25 to 0.75 inches. One edge-style brass pull lists a thin thickness of 1/16 inch (1.5 mm) and a projection of about 1-3/4 inches (44 mm), which provides measurable finger clearance.

Many listings state a limited lifetime warranty. At least one brass/edge-style pull is noted with a 30-day limited warranty.