AudioQuest Tower 3.5mm to 3.5mm Cable - 4.92 ft. (1.5m)

In Tower as in all the Bridges Falls series you'll find better metals and more sophisticated technologies including Air-Tube insulation Dielectric-Bias System and Noise-Dissipation System.

Asymmetrical Double-Balanced GeometryPurpose designed for single-ended applications Asymmetrical Double-Balanced Geometry offers a relatively lower impedance on the ground for a richer and more dynamic experience. While many single-ended cable designs use a single path for both the ground and the shield Double-Balanced designs separate the two for a cleaner quieter performance.Solid Long-Grain Copper (LGC) ConductorsSolid Long-Grain Copper (LGC) allows a smoother and clearer sound than cables using regular OFHC (Oxygen-Free High-Conductivity) copper. Solid conductors prevent strand interaction a major source of distortion. The surface quality is critical because a conductor can be considered as a rail-guide for both the electric fields within a conductor and for the magnetic fields outside the conductor. LGC has fewer oxides within the conducting material fewer impurities less grain boundaries and definitively better performance.Foamed-Polyethylene InsulationAny solid material adjacent to a conductor is actually part of an imperfect circuit. Wire insulation and circuit board materials all absorb energy. Some of this energy is stored and then released as distortion. Because air absorbs next to no energy and Polyethylene is low-loss and has a benign distortion profile Foamed-PE with its high air content causes much less of the out-of-focus effect common to other materials.Metal-Layer Noise-Dissipation SystemIt's easy to accomplish 100% shield coverage. Preventing captured Radio Frequency Interference (RFI) from modulating the equipment's ground reference requires AQ's Noise-Dissipation System (NDS). Traditional shield systems typically absorb and then drain noise/RF energy to component ground modulating and distorting the critical "reference" ground plane which in turn causes a distortion of the signal. NDS "shields the shield" absorbing and reflecting most of this noise/RF energy before it reaches the layer attached to ground.Cold-Welded Gold-Plated TerminationsThis plug design allows for a connection devoid of solder which is a common source of distortion. Instead of solder the process employs a high-pressure technique. Because the ground shells are stamped instead of machined the metal used can be chosen for low distortion instead of machinability.What's in the Box
•Single "Aux" 3.5mm male to 3.5mm male analog jack cable