command hook tape

Clean the surface so the adhesive can bond: remove dust and grime first (a dry cloth works for light outdoor dirt), then wipe with rubbing alcohol where the product instructions recommend it. Let the surface fully dry, follow any wait times listed on the package, and then attach the strip, hook, or clip as directed.

Manufacturer listings show indoor Command products maintain a strong bond between about 50°F and 105°F. Outdoor light clips are rated for a wider range, holding strongly from roughly 15°F up to 125°F. Check the package for the specific product’s recommended temperature range.

Hold the top of the strip or hook and pull the adhesive tab straight down, stretching it toward the floor or ground until it releases. Pulling straight down (not outward) removes the strip cleanly without holes or sticky residue when done as instructed on the package.

Capacity varies by product: some small clear hooks hold about 0.5 lb; certain refill or adhesive hook models list capacities around 5 lb; picture-hanging strip pairs can support higher loads (examples show multi-pair setups rated around 15–16 lb when used as instructed). Always check the package for the exact weight rating and installation instructions.

They bond to many smooth, finished surfaces including painted walls, finished wood, painted concrete/cinder block, laminate, glass, metal, and tile. Outdoor light clips are also designed for doors, vinyl siding, soffits, finished fences, and windows. Refer to the package for surface-specific guidance.