A:Â On the back of the clock, press and hold the Time Set button. The hour digits will flash; press + or - to set the hours. Press and hold Time Set button again to set the minutes. Press Time Set one last time to exit the setup.
A: I tried following the directions but my clock won’t set the time
A:Â Pick up the clock and then press and hold the clock set button to start the process. Once the hour starts flashing use the arrow buttons. Quickly press clock set button to move to minutes and once more to exit.
A:Â To turn off alarm one simply press the alarm one button repeatedly until the light next to it turns off. To do this for alarm two do the same thing but with the alarm two button.
A:Â Press the alarm button once to turn off the alarm. The alarm icon will no longer be shown on the display.
A:Â If the alarm is sounding and you want to stop it. Press the Alarm 1 or Alarm 2 button (depending on which you're using). That will stop the alarm from sounding and keep it enabled to sound the next day. If you want to disable the alarm so that it won't sound again, then press the Alarm 1 or Alarm 2 button again. Pressing the Alarm buttons will toggle the alarm from being enabled and disabled. On the display next to the time there's an icon for each alarm and when the alarm is enabled the white light next to the icon will be on and it will go off when the alarm is disabled. Hope that all makes sense. If you need additional help then please email us at "support@hellocapello.com".
A:Â There's a few things that you can check. 1) When the alarm is enabled, there's a little white light next to the alarm icon on the display. So double check to see if that's on. If it's not, press the alarm 1 or alarm 2 button and the light should toggle on/off. 2) Double check to make sure that the time and alarm hours are set to the intended AM/PM If that's not working for you, please contact us at support@hellocapello.com so we can get it working for you. Thanks for your patience,
A:Â The clock digits are 1 inch tall and the width of the full display 2.1 inches wide.
A:Â The backlight on the time digits dims but does not turn off.
A:Â When you set the alarm, after setting the hours and minutes, tap the alarm button again and "05" will flash on the display. This is the default snooze time. Press the + or - buttons to select 5, 10 or 15 minutes for the snooze timing. If you need further help, please contact us at support@hellocapello.com and we can help you out further. Thanks for being a Capello customer.
A:Â On the front of the clock in the bottom right of the time display there is an icon for "PM". When the time is "PM", the white light next to the icon will be lit. When the the light is off, the time is AM. When setting the time or the alarm time, cycle through hours setup 1-12 and it will change from PM to AM. If you need further assistance, please contact us at support@hellocapello.com and we can help you out!
A: The clock needs to be plugged into the wall power to run. Since the digits light up, the batteries would drain quickly if the clock was running on battery power alone. The backup batteries are used to save the time and alarm settings either when there is a power failure or the clock is unplugged. When power is restored, the time and alarm settings will be restored so that you don’t have to reset them again. This can be helpful for example if you need to unplug the clock to move it or if the power is briefly interrupted during the night, the backup feature will ensure that the time and alarm are correct so that you’re still woken up in the morning.
A:Â Ooops, that's not correct in the details! The clock is 5.9" wide at the base, 4.5" tall and 1.8" from front to back.